Questions & Answers for: GE SpaceMaker match point

...You should be ok using a motor from a different model as long as all the numbers and wires match to the original motor itself. BTW, these motors sell on auction sites for about ...

...under the above unit (to provide light over the stove) burned out and I put them on the counter to match up with a replacement. They got thrown out by accident. The place where you insert them is at ...

...my ge spacesaver microwave. This is a common item. Take the bulb to a home depot and they will match it for you or direct you to a local source. please mark my answer as a

point you can buy these at home depot bracket is the same and holes in the top match so you dont have to drill holes. the ge jvm1443 is hard to find they made these in 2005.save your self the headache

Samsung SMV blower installation Which way is the blower on top of the microwave is suppose to be placed? My microwave shuts off after 3 min and I think that the blower on top of it is not positioned ...

...burn out and produces no power. It can be replaced for abourt $2-3. Just keep your old bulb and match it with one at a radio shack or other parts

is possible if you know how to open it.Then you take it out and go to Lowes or Home Depot have them match it up to model on bulb.Then install it and [ MAKE SURE BEFORE YOU START UNPLUG MICROWAVE ]Then

...on other side. The bulbs or 40W appliance bulbs. Take the old one with you to hardware store to match it up. Reverse your steps to put new ones

power won't shut off when door closes Actual built in, but told this is a close match One or two micro switches are defective, "door switch"

...a template so that you can drill holes into the bottom of the cabinett so the holes you drill will match up with the holes in the microwave. Once done then there should be screws and fiber washers. ...