point setting on 77 ford I have a '77 Ford f-250 w/a 460 cid engine. The original specification label says the spark plug gap is .042 - .045. The points info says: Gap, none, dwell, none. Timing is 12
...to make sure i have them right 16 to 20 thou should do it. A clean nongreasy feeler gauge or a match book cover will do. ...
...a 1970s Ford 400 truck What is the points gap for a 1974 Ford 400 truck engine? the thickness of a match book cover is how i always did it and worked perfectly,hope this helps
...point? it should match the flow - gas tank to engine. So yours is backwards. It faces towards the front of the vehicle. The arrow represents what way the fuel flows and the fuel flows from the gas ...
match book and place it between the two point breakers. 2. Loosen the point hold down adjusting screw and move the base of the points with a screwdriver (look for adjusting nothches), until there is a
point straight down. finally the top gear keyway should be pointing straight up. alittle mark on the gear teeth should match a mark on the lower gear teeth. here is a link on ebay to a factory service
...off and none of the new wires are numbered but the old wires are? i know the firing order but the new wires are different sizes than the ld ones Match up the sizes and number them with a ball point ...
...check your distribuitor rotor points to spark plug cable for piston #1 first front to back, if not match your timimg belt
...point gap of ford laser 1983 where I come from - we always used a match book cover to set the gap on the points and then used a dwell meter while the car was running. the match book cover sounds a ...
instrutions on how to install points on a 1955 ford f-100 you need a set of points and condencer install the points turn the motor by hand un till one of the lobes are in line with the brown some ...
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,348 Questions
2,636 Questions