Questions & Answers for: Briggs & Stratton match point

need to know gap for points on 3 and half hp i remembered how i used to set points in my cars with a match book cover. it worked great.

...point gap setting for 8 hp Briggs and Stratton gas engine If it is an older BS it will be .015 That was standard. In fact an old match box cover would work to set them if you could not find a guage ...

...etc. Replace the "Key" with a 50 cent part from local hardware store bring in the old one to match

match. With wet fingers pinch the ends of the rope while hot/melted until it is the same size as the rope. Form a point on the ends - Install the new rope in the handle by threading it into the handle

match. With wet fingers pinch the ends of the rope while hot/melted until it is the same size as the rope. Form a point on the ends - Install the new rope in the handle by threading it into the handle

...match to light the end of the cord and once it ignites, use an old rag to pull and form the end into a point. Notice which way the pulley in the starter assembly rotates and hand spin it in that ...

...match to light the end of the cord and once it ignites, use an old rag to pull and form the end into a point. Notice which way the pulley in the starter assembly rotates and hand spin it in that ...

...point of blade is and rotate blade around if both ends don't match mark on deck highly likely bent blade or spindle. Id say bent blade more likely. In my experience Gator blades in general work ...