Questions & Answers for: master temp

My Pentair Master Temp 400 gurgles when I try to start it. I think there is water in the heat exchanger. How do I drain it? leak replace exchange

My master temp 400 LED light blinks 3 times (ignition lock out) how can I fix it? check gas if on check ignitor

exhaust elblow for master temp 200 i need an elbow to vent my master temp 200 up and out of my machanical room. have HVAC do it maybe need exhaust fan

master temp 400gas heater? flue fusible link in top flame sensor by ignitor Hy my pulsar 150 slow running bymitake off I try start not start continue kiks after 10 to 20 munitus I again start plies my

...master temp 400 rust coming out of pipe Little chip of it looks like rusted pipe are coming of jacuzzi jets. Only pipes that could be copper are the ones in heater. Happen to anyone else? bad water ...

Pentair Master Temp 250 Code 126 bad temp sensor

What ohms should the glow igniter on a master temp read less than 75 ohms

master shuts off after 30 seconds no matter where temp set at U may have a problem with the over temp shut off , or your thermostat is bad so the over temp kicks in . DO NOT REMOVE OR BYPASS OVER TEMP

i have a master temp 300 the burner stays lit for about 6 seconds then stops More than likely it is your Flame Sensor/ Ignitor Module.

My new Pentair Master Temp control board does not respond or have lights same as the old board What could be the problem? bad board, have technician test it.