Questions & Answers for: Nissan Pickup master

...is soft, is there an adjustment? This is probably a hydraulic clutch. check for fluid at the clutch master cylinder, if empty check for a leak at either master or slave cylinder (on the side of the ...

i have a 91 nissan d21 and cnt find the slave cylinder or master slave cylinder? The master is beside the brake master cylinder, between the brake cylinder and the fender. Follow the line down to the ...

1987 Nissan PU, I replaced the master and slave clutch cyls. I bleed the system and there is no air in the lines but peddle does not get hard. Could the new master or slave cyl be bad? I see you can ...

cluth has to be on floor to shift your truck has a hydraulic clutch, which has a master cylinder next to the brake master cylinder. Check the fluid level. If it is low or empty, you have a leak in the

...clutch line in 1997 nissan pu xe 2wheel drive.\r\nhave removed old fluid and removed and overhauled master cylindar. refilled lines and resivour with brake fluid. clutch peddal has zero pressure/draw ...

clutch looses pressure, leaking by clutch peddle Clutch master cylinder is leaking out of piston cup.Detach from clutch pedal, disconnect hydralic line, and remove 2 firewall retaining bolts or nuts ...

...you apply pressure to the clutch pedal a rod inside the vehicle under the dash pushes into a clutch master cylinder, (almost like a brake master cylinder without the reservoir, as the clutch master ...

...First check your brake fluid, if it's low than you have a external leak. If it's not low, the master cylinder has failed internally.Lokk for brake fluid leaks behind each wheel and at the back ...

clutch not worhing air getting in hyraulic lines Is your clutch master cylinder about empty,your slave cylinder could be bad and leaking,also look for leakage at clutch master cylinder,go to ...

...what would cause it not to pump up and stay? Most likely causes: air in the front system or a bad master cylinder. Make sure the master cylinder is bled out at the output lines. Try clamping the 2 ...