Questions & Answers for: Chevrolet Tracker master

can not get a pedal, replaced master cylinder twice, bled everything, no pedal...can't seem to get fluid out of the 3 front ports on the master cylinder...could both master cylinders be defective, or ...

...You should have the vehicle on a level surface, then starting at the farthest wheel from the master cylinder (right rear) have your helper pump the brakes several times until the pedal is

...on my 1999 chevy tracker are soft and slow to respond when pushing the pedal down. The fuid in the master cyclnder is full and there are no leaks. What would cause this? its likely you have air in ...

brake pedal goes to the floor , replaced master cyclinder , replaced front pads , adjusted rear brakes , bleeded all the lines , still the same . you need to check and see if these have a brake pedal ...

...for fluid levels first. If you are loosing resistance on the pedal, it is possible that the clutch master or the slave may have gone

clutch goes to the floor I would check to see if there is a master cylinder on the clutch or it possibly could be a broken cable or a worn pressure plate.

My brake pedal went to the floor, brought it in...They told me it was the Master Cylinder. They changed it and put in a brand new master cylinder but it still seems like the brake pedal goes further t

My brake pedal is going pretty far to the floor, I just replaced the master cylinder but the problem is still there?? I had my brake pedal go to the fllor, Brought it into a garage....They inspected ...

2007 dodge dakota,replaced calipers,pads,rotors,rear wheel cylinders,shoes,lines and 2 master cylinders.bench bled mc and bled all wheels several times but cant get pedal to stay up.is it possible i ...

...the reason when sitting at a light or stop sign my brake foot goes down to the floor board Your master cylinder could be low or your parking brake is slighty applied or not releasing all the way ...