...Mass air flow sensor electrical connector Tube clamp at the electronic throttle control actuator Air cleaner to electronic throttle control actuator tube, upper air cleaner case Mass air flow sensor ...
...mass air flow sensor, this is used to tell the computer how much air is entering the engine, check the air filter,and clean the sensor with CRC mass air flow cleaner, with engine off. hope this ...
mass air flow sensor My auto technician says i have a problem with my mass air flow sensor in my 1997 nissan pickup,what is that for ? maf sensors identify the amount of air flow flowing in the intake
...Mass Air Flow Sensor voltages. Verify good battery voltage to the Mass Air Flow Sensor on the White/Black wire. Verify good grounds for the Mass Air Flow Sensor on the two Black wires - look for 0.05 ...
...Mass Air Flow (MAF) sensor/Intake Air Temperature (IAT) sensor is located in the air cleaner case. The Intake Air Temperature (IAT) sensor is an integral part of the Mass Air Flow (MAF) sensor. Looks ...
...Mass Air Flow Sensor Circuit Range/Performance ErrorPossible causes- Dirty mass air flow sensor - Dirty mass air filter - Mass air flow sensor harness is open or shorted - Mass air flow sensor ...
Question about 2003 Altima
...MASS AIR FLOW -MAF use this, for now i am guessing, until i see the correct codes your are getting. this could be the 1 you may have below, please read it........ P0103 Mass Air Flow Sensor Circuit ...
...Mass Air Flow Sensor on the Red/Green wire. 2. Check for 5.0 volt reference to the Mass Air Flow Sensor on the Red wire. 3. Check the Mass Air Flow Sensor ground on the Black wire - look for 0.05 ...
Question about 2001 Altima
...mass air flow sensor Intake air leaks Dirty mass air flow sensor Dirty mass air filter Mass air flow sensor harness is open or shorted Mass air flow sensor circuit poor electrical connection Before ...
...mass air flow sensor? 1989 nissan d21 hardbody i want to test the coil and mass air flow sensor. On the coil, primary resistance should be 0.8 to 1.0 ohms. Secondary resistance should be 7.6 to 11.4 ...
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,308 Questions
1,122 Questions
1,306 Questions