...into safemode. i called deelership and i have the code, but there is another button i have to mash while pressing in the code and the deelership didnt know what button that would be. could you ...
...,fluid should be rolling out of hole in not add. once fluid level is good turn key on,(not running) mash gas pedal tp floor for 15 secs turn key off and on and off again.that resets trans ...
...be greatly appreciated. Thanks for reading. try the resetting proceedure.turn key on engine off mash gas peddal to floor for 15 secs let of peddal turn off key. may take some miles for tcm to ...
...the dealer they say modules are not communicating to each other , any ideas turn key on engine off mash gas pedal to the floor for 15 secs let off of pedal turn key off this resets tcm Tramission ...
tdi has n't any pickup when accelerating 2003 jetta I can mash the pedal to the floor and get no response in acceleration Sounds like a clogged intake to me. TDI's like to be driven hard - if you ...
...like the floor mat or garbage doesn't obstruct it's travel. Turn key to on, but don't start it. Mash the pedal to the floor and hold it there for 10 seconds. Release pedal and turn off key. -you ...
no tail lights or park lights until i mash the brake padal Dont know what year, But the multifunction switch( turn signal switch) is probably is bad.
...and a rear drivers side caliper that appeared to be locked up, bled the brakes all around go to mash on the brakes and the pedal feels real hard now after replacing a rear passenger side sensor ...
Question about 2000 Beetle
...fire on pulg wire take gas slow jump an backfire when give mush gas sercive light blinks when you mash gas fast was runing good with miss when mash pelter now it losing power fast cant get it to ...
...converter is stopped up and needs to be replaced i seen this on a chevrolet and a pontiac,you mash the gas but it don`t go
Usually answered in minutes!
1,967 Questions
1,322 Questions
1,226 Questions
1,072 Questions
1,150 Questions