Questions & Answers for: mark point cam timing engine

...mark on it that should point almost straight down. There is a V cut into the oil pan that actually should line up with the cranshaft timing mark. BE VERY CAREFUL because if you rotate the crankshaft ...

Ad

Question about 1992 G20

1 Answer

...point, a mark stamped onto the crankshaft sprocket is pointing directly upward (toward the camshaft). The camshaft sprocket is then temporarily bolted to the cam and used to rotate the cam until a ...

Ad

...E)( left cam I) at that point the loobs on # I cyl. Int & Ext open all four valves at the same time both cams should have the marks point to 12 o clock and the crank lines up with mark on the ...

Question about Motor 2003 Sonata

1 Answer

...point on engine this mark is approx at 11 o clock position when viewed if not rotate engineanother rev till both marks line up release tensioner (renew it !) fit new belt from crank anticlockwise to ...

Question about 1983 Chevy

2 Answers

...timing to the cam to the crankshaft is on a 1983 454 Chevy engine. 8 degrees before tdc crank timing mark at top center, cam mark top center will be TDC No.1, cam mark pointing to crank mark TDC No. ...

...point, a mark stamped onto the crankshaft sprocket is pointing directly upward (toward the camshaft). The camshaft sprocket is then temporarily bolted to the cam and used to rotate the cam until a ...

...point directly at the mark on the engine at the 12 O'clock position. Once the timing belt is installed and the tensioner is set, rotate the crankshaft 2 full turns to verify proper alignment. If all ...

Question about 2000 Protege

1 Answer

...timing marks diagram if i knew what engine this was i might remember from previous work but i seem to remember doing a water pump on a 4 inline single cam one and the marks were easy even for me but ...

...mark pointing down or do they both point upward On the 4 cyl engine, you line up the crank pulley with the timing mark and the cam gear with the pointer on the timing cover. On V6 engines the cam and ...

the cam sprocket are pointing at each other. On the crank sprocket the mark is pointing up, the cam sprocket mark is pointing down. If you have a different vin than I posted, the info may be different

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...