...manifold bolts and carefully lift off the manifold. To install: Fig. Lower intake manifold bolt torque sequence-3.8L (VIN K) engine Clean all parts well with degreaser, especially the gasket seal ...
Ive replaced my manifold gaskets on 2002 loncoln ls v6 and have a long bolt left over. Need diagram or schematic. if its a manifold bolt its probably from the hole in the centre of the manifold- it's ...
...manifold bolts torque and rocker arm torque engine specs Intake Manifold Coolant Pipe Bolt .... 89 in lbs (7.4166 ft. lbs) Lower Intake Manifold Bolt .............. 115 in. lbs (9.5833 ft. lbs) Upper ...
...manifold bolts Exhaust manifold bolts-first pass 11 Lb/Ft. Exhaust manifold bolts-final pass 18 Lb/Ft. Exhaust manifold heat shield bolts 7 Lb/Ft. Note: To torque bolts & nuts, start in center ...
manifold bolts and stud. Clean the upper intake manifold bolt threads. Remove or disconnect the following: Upper intake manifold by lifting the back of the intake and sliding the manifold forward from
manifold bolts. Install the lower intake manifold bolts. Notice: Proper lower intake manifold fastener tightening sequence and torque is critical. Always follow the tightening sequence, and torque the
Question about 2000 Lanos
...manifold bolts to 14 foot-pounds of torque in a crisscross pattern, beginning with the bolts at the center of the manifold and gradually working to the ends of the manifold. Tighten the exhaust ...
Question about 2000 Lanos
...manifold mounting bolts to 16-18 ft. lbs. (21-24 Nm). Install the manifold-to-converter exhaust pipe and replace the converter air pipe bracket to the stud. Raise the Engine cradle and install the ...
Question about 2000 Lanos
...Bolts Manifold Spark Plugs Lug Nuts Intake Exhaust 1998 2.4 (2389) KA24DE 1A Step 1: 22 ft. lbs. 2B 10-12 ft. lbs. plus 60-65 degrees or 28-33 ft. lbs. 3 4C The cylinder heads and the lower intake ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions