...lamp comes on after 5 sec I cleaned the throttle area and checked for false air through inlet manifold. All good. Try removing the Idle rev valve and cleaning it with carburettor
...will not idle and dies. you may have a vacuum leak, check all the vacuum lines around your inlet manifold, carbi etc for cracks or ones that have come off their fitting. Check all the retaining ...
whare is the starter motor located on a deawoo lanos the starter is located under neath the intake manifold. access by jacking up the car. large red battery cable goes directly to starter motor.
...PO106,PO121) mean for a 2000 deawoo lanos. OBD II Fault Code OBD II P0106 Fault Code Definition The Manifold Absolute Pressure Sensor/Barometric Pressure Sensor measures the rise and fall of the air ...
water in oil Bad head gasket or bad intake manifold gasket.Either one will cause water in oil.Do not run engine will cause bearing damage.gaskets way cheaper than new engine.
Question about 2000 Lanos
...working on a 1.6- or 1.8-liter engine, the torque specifications are the same. Intake and Exhaust Manifolds Tighten the intake manifold bolts to 14 foot-pounds of torque in a crisscross pattern, ...
...head gasket put in time and remove valve cover, front engine cover, timing belt ,exhaust at manifold, intake manifold and remove head bolts, pull head clean all surfaces replace gasket after ...
...replaced IAC Sensor Valve has been replaced Mechanic is now looking at replacing the Air Intake Manifold Gasket, could this fix the problem? Yes if its a vacuum ...
Oil leak from behind exhaust manifold I have an oil leak which i am not 100% sure its location. I have just recently done the valve cover gasket and that is fixed. I think it may be coming from right ...
how do you take the iac off a deawoo deawoo lanos 1.6 It is bolted to the intake manifold near the throttle valve.
Usually answered in minutes!
554 Questions
540 Questions
410 Questions
304 Questions