help with manifolds i bought new manifolds and they have like to small holes in the side when i look in the book on my truck it is showing some tubes what goes there i throw the old ones away it is a ...
Question about 2001 Durango
...on a 2001 dodge durango? VERY SIMPLE!!!!! 4.7LThe MAP sensor is located on the front of the intake manifold. An O-ring seals the sensor to the intake manifold. Disconnect electrical connector at ...
...(IAT) sensor electrical connectorRemove the air inlet hose from the throttle body.Disconnect the Manifold Absolute Pressure (MAP) sensor electrical connector.Disconnect the PCV hose ,purge hose
where is the IAT sensor for a 99 5.9 diesel ? The two-wire Intake Manifold Air Temperature (IAT) sensor is installed in the intake manifold with the sensor element extending into the air stream: This ...
...3.7 liter, #1 below: 4.7 liter: 5.7 liter, #2 below: IAT SENSOR LOCATED ON LEFT SIDE INTAKE MANIFOLD ON 3.7L AND 4.7L ENGINES ON THE 5.9L ENGINE IAT SENSOR LOCATED AT THE FRONT OF THE INTAKE ...
Question about 2001 Caravan
Had exhaust manifold replaced since then my 2001 caravan bucks and blows black smoke little to no power Car will accelerate briefly then bog down. Engines seems fine until you drive it. Black smoke ...
Question about 2001 Caravan
where are the 7&8 manifold bolts located on 2009 5.7 dodge ram hemi engine 2009 if they are the same as the manifold studs, then they are on the side of the engine, and they are what secure the ...
Question about 2010 Caliber
code p2004 saying intake manifold runner control sturck open. bank 1 Check engine light came on and code is showing p2004 saying the intake manifold runner control stuck open bank 1. Explanation ECM ...
2008 dodge avenger code p2004 Intake Manifold runner control stuck open - bank one: - Intake Manifold Runner Binding Or Sticking - Faulty Manifold flow valve - Manifold flow valve harness is open or ...
Changing the exhaust manifold gasket on my 1995 dodge intrepid Kayla, Not sure what your question actually is. But one thing to be prepared for is a damaged manifold. The manifold has to handle very ...
Usually answered in minutes!
2,271 Questions
2,049 Questions
1,788 Questions
1,616 Questions
1,496 Questions