2002 Grand Prix GTP Supercharged The lower intake manifold is leaking. People at work indicated that the problem with the GM lower intake manifolds is that the manifold warps causing the gasket to ...
do you have to remove the exhaust manifold to replace the starter? No it You have to remove the intake manifold, not the exhaust manifold. You have to remove the top engine cover to expose the bolts ...
My starter gave out yesterday. I didnt know it was inside the intake manifold. Either way i started the job last night, i am having a hard time pulling out the manifold. I already loosened the clamp ...
...I have pasted the procedure from autozone.com below. Because this requires removal of the intake manifold, please be as sure as possible that your starter needs replacement. If you have any doubt, ...
...to change starter The starter on that engine is mounted between the cylinder heads under the intake manifold. You will need a set of injector O-rings and an intake manifold gasket set to do the ...
where is the purge valve located on a 2004 Buick rendevous On the side of the intake manifold follow the plastic vent line from the canister to the intake manifold. It usually is within a few inches ...
torque settings for manifold bolts What are the manifold bolt torque settings for intake manifold on 2000 Cadillac Deville? Check this Caddy link for torque specs. intake manifold torque sequence 10 ...
Question about 2006 DTS
...do I locate and change the map sensor on a 2006 Cadillac northstar dts 4.6L & 6.0L Engines The Manifold Absolute Pressure (MAP) Sensor is mounted in the front of the intake manifold behind the ...
Question about 2006 DTS
There are 2 exhaust manifolds on cadillac 4.6 l bank 1 sensor 1 is in rear of engine on exhaust manifold and bank 1 sensor 2 is in front of engine exhaust manifold just before the cat. No room to work
Question about 2006 DTS
I need to remove the exhaust manifold on the right side of a 94 4.9l engine in a cadillac deville. It has a broken bolt in the exhaust. What is involved in removing the manifold? I suggest you use all
Usually answered in minutes!
1,356 Questions
1,298 Questions
1,226 Questions
1,118 Questions
921 Questions