Questions & Answers for: main stand

...15 mins and then off and the stand by light starts blinking Take out all the cables unplug from mains for an hour ,plug it back in with no cables connected ,turn volume to full if it turns off

It seems a little louder than usual. what could this be. LE stands for "Locked Motor". It means the main pump motor is bad

what is the easiest way to put it on the main stand Left foot on main stand, turn bars to the left, grab rear footrest for ballance and put all your weight on your left foot...dont pull the bike.

stand-by, it could be also caused by the main board and or the ballast boards. If it is caused by the ballast boards, it should give you error code with the red stand-by light blinking 11 or 13 times.

...MAIN STAND FOR MY YAMAHA XJ600 YEAR 1992, MODEL DIVERSION (SECA2) CAN ANYONE HELP ME IN SUGGESTING WHERE CAN I FIND A NEW OR USED MAIN STAND FOR MY BIKE. THANKS. GOD BLESS YOU ALL. NAJAF ALI MIRZA, ...

...can be irksome at times ,it will not start if the side stand is down even pulling the brake levers in it will not start like this only if the side stand is up ,so put it on the main stand and try ...

...the pin will be pushed in. if it stalls on the main stand i had a friend who's bike had a safety feature of which it wouldn't start with the back wheel in the air. depends on which stand it ...

main board sends 'stand by or Power ON' command to the power board which then makes other necessary voltage for the main board as well as other sections. If the power board does not receive 'Power On'

...stand alone you might have to disconnect any battery fitted and remove the switch. Remove the wires from the back of the switch. If it is mains powered either unplug it at the wall or remove the fuse ...

...stand by its the main board if you don't then its the power supply.if you change the main board out and it don't work then your Tcon board is bad too. thats the problem 99% of the time when you have ...