...control board. The main board is on top and the motor control board is behind the lower panel. Sometimes the harness to these boards become loose causing this error. You would have to get at them and ...
main control board ? Worn Transfer Belt Troubleshooting Procedure: 1. Make sure the high voltage cable and trigger lines are properly connected to the high voltage supply board, I/O control board, and
Question about 6513 Copier
while heating, and goes through menus on its own or keypad unresponsive. Resetting it, restores use for a short time.Main control board, or the keypad display board? It could be the main control board
Question about 6513 Copier
...main control board? Hi, checking user manual there's no soft reset option so maybe the main board is faulty too, usually when there's a damage by lighting in power supply this also reaches the main ...
main board might have to be replaced. If so, a software [firmware] update too might be necessary. Before going further; try a hard reset first. If it does not help you, replace the main digital board.
Question about New Original TX42F430S Remote Control
...main system control IC, at its main digital board. Now it do not work, and why you can't power ON the set, either by remote control, or with the front panel control. Fault at its main digital board. ...
Question about New Original TX42F430S Remote Control
...main board under warranty. Everything worked for about a year and then went dead again. This time I replaced the main board and power supply board myself since the TV was out of warranty. That fixed ...
Question about New Original TX42F430S Remote Control
...control. Fault at its main digital board. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. ...
Question about New Original TX42F430S Remote Control
...control board,I checked the U1 AIC2857 its output less 2volt Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If ...
Question about New Original TX42F430S Remote Control
...main control board. Most systems out there have indicator lights right on the main control board. This may be the case for you. Its the main control board. Have you tried resetting the unit and see ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions