Questions & Answers for: lower arm spray lg dishwasher

...lower arm and cleaned it. I have also disassembled the filter assembly to make sure it is clean. No obvious residue built up. Help!! HI It might be a broken sump assy. Which is the part under the ...

lower arm. So, if you are looking inside the dishwasher to see which arm is spinning, you just have not opened it when the lower arm is turning. if the root problem is that your dishes are not getting

...lower arm. It is called Vario - with a motor that drives a check valve to route the water. So, If you just open the dishwasher while it is running and look to see if all the spay arms are spinning, ...

...lower arm holes is about 4 to 5 inches high with no rotation. Screens clean. Nothing in impeller. All arm holes clear. Water pump turns by hand. Water drips from nut that holds upper arm in place. No ...

lower spray arm to get the filter out. Grab the spray arm and lift up and out. Use a flashlight to inspect the entire area, especially in the rear area that has the valve that alternated sending water

...arm is working fine. I am suspect of the "Vario Spray System" which alternates, the pumps full power, between the upper and lower sprayers...... If anyone has any other ideas, or experience with this ...

...arm and lower spray arm- dishes are not getting clean- and it smells so bad- any ideas? our LG dishwasher smells so rotten- the dishes are not getting clean- and there is a slimey coating- all inside ...

...lower arm is slow to start spinning. It spins then stops, and continues this for abut 3 cycles. Then, the arms never seem to quite fully get up to speed. Als, when I set it for "top rack only" it ...

...lower spray arm. No water coming out of the upper spray arm. I changed the water inlet valve, and there isn't any difference. I also cleaned the filter,checked the impeller and water does come out of ...

...lower spray arm is working best. I also cleaned the jet holes but still the upper arm is not doing the best cleaning. What could be the problem please? There are some ideas in the link. ...