...There is a sensor located on the oil pan. If the plug-in to this sensor comes loose it or if the sensor fails, it will send the low oil signal. You are wise to check the oil to confirm it is not
low tire pressure warning light blinks three times. a) Check tire pressure on all 5 tires to make sure all is well in pressure land. b) Set parking brake c) Turn on Key, then quickly turn headlamps on
...over today..just brakes msg..PLEASE HELP!! Thanks you Have you tried to jump start the vehicle ,low voltage ? Loose battery connection's . Turn on the headlamps ,are they bright ,seam normal ? If ...
...sensor, It's either in the pressure line or on the back of the pump. It sends a signal to the PCM to increase the RPMs at low speed when more power from the pump is required when parking and
...low speed setting, a signal is applied to the BCM. The BCM then applies battery positive voltage to the coil side of the ON/OFF WPR relay through the relay control circuit. This energizes the relay, ...
...circuit is at the low speed signal voltage, and the body control module (BCM) supplies redundant voltage to the wiper relay via the wiper diode. This info is out of hummer factory service manual
...Signal Circuit Low • DTC B0528 Right Turn Signal Circuit High • DTC B0529 Right Turn Signal Circuit Open DTC B0530 Right Turn Signal Circuit • DTC B0532 Left Turn Signal Circuit Low • DTC B0533 Left ...
...signal to the headlamp relay through the low beam headlamp relay control circuit. The headlamp relay will illuminate the low beam headlamps. Install a scan tool. Turn ON the ignition, with the engine ...
Usually answered in minutes!
658 Questions
180 Questions
91 Questions
110 Questions
71 Questions
