...signal applied 11.8 volts, but depress brake and only .08 volts displayed. not enough for trailer to pass vehicle inspection. checked/cleaned all grounds, all new fuses, no visible frays in wiring ...
...signal from this O2 sensor, if the voltage low (.10-.25 volts) try spraying propane into the air cleaner to see if the O2 volts go up, it should go to around .75 volts, if nothing happens then the O2 ...
...signals at all (on dash or outside), no hazard lights and no horn. I do have headlights (high and low) as well as wipers and brake lights all working. I don't have an owners manual so can't just ...
low tire pressure. The lamp for the signal is close to it and is showing a little light throgh it so you can see it a little. Not to sure how to fix that one. Those clusters are sealed up preaty good.
...low fuel light came on and it wont register the full tank of gas. There are only 49k miles on the truck. I just cannot believe this. Just purchased 3 days ago. it is the fuel level sender. the board ...
Question about 2005 Silverado
...low beam just 2 come on. I have a round knob on the left middle dash to control lights. I if I turn it to the empty circle then the head lights go off and the signal lights stay on. I think that is ...
...headlight circuit(behind the pull knob) and no change.. any suggestions??? Button floor click or pull turn signal towards you easily relay is on maybe you have blown your low beam replace your ...
Question about 2005 Silverado
...Low beam control is determined by a signal on the headlamp dimmer switch signal circuit from the multifunction switch. When the headlamp dimmer switch signal circuit is open, the BCM grounds the ...
Question about 2005 Silverado
...signal circuit for an open/high resistance. Test for less than 1 ohm between the SDM low reference circuit terminal 36 and the front end sensor circuit terminal 1 harness connector. ? If greater than ...
Question about 2005 Silverado
...low. This also causes the charge indicator to turn ON and the PCM/ECM to set the DTC. What engine is in your truck ? DTC P1638 The powertrain control module (PCM) uses the generator field duty cycle ...
Usually answered in minutes!
1,100 Questions
795 Questions
556 Questions
393 Questions
396 Questions