...low and sometimes my car will just cut off. I was told that I just needed to get the timer readjusted. does that sound right to you? Yes, the first thing you should do is have the timing checked and ...
...ford focus zx3. I have replaced the C-Converter, and the EGR Valve. No codes are being set. The engine sound as if it is loping at low RPM, but seems to run pretty good at higher RPM's. Check the ...
Question about 2000 Focus
...low gears i have a 2000 ford focus and it keeps jerking and the check engine light came on could be the iac valve, idle air control valve. at the beginning check for air leaks, a scanner will be ...
...low and dies. It is a 200 Ford Focus XL. check for any vaccum lines that may be unplugged. then remove the air intake tube and clean the black carbon build up from around the throttle plate.use a ...
idling, like at a stop light or drive thru, it stalls (not all the time, but a lot). Sometimes, it idles real low to where it feels like it is going to stall, but something kicks in and it idles again
...ford focus, the revs seem pretty low when it ticks over. under braking the revs drop even lower, sometimes to the point where it cuts out. Any ideas ? You have described a concern where as the idle ...
...due to low pressure. the idling problem sounds like a bad idle control valve. is the check engine light on? if it is and a p0171 code(system too lean) is present you should check for vacuum
Question about 2001 Focus
...idling when cold and will stall when warm, why? I have a 2.0 Ford Focus that idles really loud and rough. Once the car gets really warmed up it gets better but the idle will go so low the car stalls. ...
...Idling too low i asked about this sunday, i have done the idle reset proceedure as described in owners manual. seems a little better but is idleing very low.it almost seems normal if you turn on the ...
...low when cold Have you replaced the spark plugs and wires? Also,a dirty MAF sensor can play hob with your idling. GENTLY clean the wires in the MAF sensor with a MAF sensor spray and a clean ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions