thread breaksneedle may be in backwardsRaise the needle bar to the highest point, then loosen the clamp screw to remove the old needle, place the new needle in the clamp with the flat side to the
thread to seat properly in the tension guides. If the loose threads are still appearing under the fabric, try tightening the upper tension. The upper and lower threads should meet in the middle of the
Question about Sewing Machines
...thread is so loose - what is wrong? What is wrong with my model 3610 when doing zig zag the bottom thread is so loose.... the needle thread tension is too loose tighten it up so that it pulls the ...
...thread is loose at bottom When the bobbin thread shows on the right side, the needle tension is too tight or the bobbin thread, too loose, as shown in the middle drawing at right. When the needle ...
Question about Sewing Machines
...foot when threading the upper thread so it will seat properly in the tension disks. If the bobbin thread is loose, then the bobbin tension may need to be tightened. Understanding Thread Tension ...
...the presser foot while threading so the thread will seat properly in the tension disk. If the bobbin thread is loose, then the bobbin tension needs to be tightened. Understanding Thread Tension ...
Question about Toyota Sewing Machines
...thread is too loose. However, first, verify that the thread is completely seated in the tension mechanism. When threading every thread on your machine, make sure the presser foot is always UP. When ...
Question about Sewing Machines
...stitches. ... Loose thread tension will create loose loops of thread that can cause the needle to catch and create more of a mess.
Question about Sewing Machines
...thread is loose?... upper top spool or bottom bobbin? If possible use a different color thread on top or bottom to be sure. If upper thread is not pulling back with take up arm you need to increase ...
Question about Sewing Machines
...thread is loose, test sew with a different color top thread. Other typical causes for loose top thread are debris in the hook race, improper threading, or top thread not unspooling evenly
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions