Question about LS-2125 Mechanical Sewing Machine
...loops on the bottom the problem is on the top.. If it loops on the top, the problem is on the bottom. Sounds like #1 your bobbin is wound very loosely , #2 your bobbin thread has to go thru its ...
...top thread is perfect the bottom thread is in loops Try pulling the bottom thread to your left as tight as possible before any sewing, this gives it a better chance to anchor itself in the
Question about CS6000i Computerized Sewing Machine
bottom....help? Loops on the top of the fabric are usually caused by the bobbin thread not in the bobbin case tension correctly, remove the bobbin and reinstall it. You should feel a slight resistance
Question about CS6000i Computerized Sewing Machine
...Loops on bottom indicate a top thread tension problem. Make sure needle is the correct size and not bent or brokenMake sure it is threaded properly with the lever UP. Do a test stitch. If ...
Question about 1740 Mechanical Sewing Machine
My thread on the bottom of the material is in small loops. What am I doing wrong? try changing the needle adjust the top thread tension to stop the loop
Question about 1740 Mechanical Sewing Machine
...brother Ls-2B837 loops underneath material 1. Always make sure you are treading the sewing machine with the foot in the UP position. 2. Loops on bottom mean the top tension is too loose... tighten
...loops too big you need to tighten top or bottom looper tension or both. The tighter the tension the smaller the loop. Also if you're not running the material straight with the knife it can make loops ...
Question about 1740 Mechanical Sewing Machine
...loops on bottom. The machine is not even a year old. Help top thread tension not tight enough make sure that the thread is between the tension plates and not behind them It is always due to incorrect ...
...loops and loose stitches Try re threading the needle. and try a new needle. Make sure th thread and needle are the size required for the material used. Make sure the needle tension is correct for the ...
Question about 1740 Mechanical Sewing Machine
...material. Is the tension too loose? The machine has a tension wheel but no guide markings to jndicate tension amount. Tried turning it both directions, with variable results, none of which seem to ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions