Questions & Answers for: Dodge loop setting

...Indicators: MIL Details EVAP Details Trouble Code Conditions: Engine at idle speed in closed loop for 200 seconds, BARO Sensor signal less than 8,000 feet, ECT Sensor more than 160ºF, no ...

Front U Joiints have play in them. Knocking sound. How hard to replace myself? Unbolt the loops on the yokes at each end and pry them loose. The shaft will come out with a little wiggling. The old ...

...are gapped properly and that all sensors are performing correctly since they are a part of the loop that causes the computer to set the timing off

Is there a special thing you have to do to open loop computer to set timing on a 97 3.9 dodge v6 Base ignition timing is not adjustable. The distributors do NOT have centrifugal or vacuum advance. ...

...- See the Diagnosing Your Fuel System page. Diagnostic Method - Trigger Parameters - In closed-loop - Sensor output indicates lean for more than 715 seconds (11 minutes, 55 seconds) Results If ...

...- See the Diagnosing Your Fuel System page. Diagnostic Method - Trigger Parameters - In closed-loop - Sensor output indicates lean for more than 715 seconds (11 minutes, 55 seconds) Results If ...

...to time. Some times when just starting, other times went restarting , engine warn but not in closed loop. Have replaced all o2 sensors.Code will sent and when cleared will run 600 miles with no ...

Drive cycle 1998 3.9 Dakota It has to close loop, drive40-60 Mph 8 minutes, stop idle for 3 minutes on drive,next, drive over 25 Mph for 2 minutes,stop, engne off for 10 minutes to set oxegen monitors

...for four times the time it took to set the code (roughly 48 minutes), the engine will run in closed loop mode, which forces it to run rich, preventing it from running lean (running lean can cause ...

...is an informational code to inform the technician that transmission has been operating in an open-loop line pressure control for 3220 kilometers (2000 miles) or 1000 2-3 upshifts resulting from a ...