Question about NN-C994S Convection/Microwave Oven
...loop P1 AND P2 externally(as i believe this are looped inside transfomer,and due to some reason gets opened) Please guide on possible cause and rectification There is something on the secondary side ...
...loop current When I try to send a fax it comes up as no loop current then tries to retry. One side of the phone line to the unit is bad. This could either be in your cords, internal facility wiring, ...
...current sense loop on H.V. Board. Possible Causes: 1. Interlock switch (contacts 2 & 3). 2. Open thermal cut-out (magnetron). 3. Open/loose wire. 4. Power relay. 5. H.V. Board. 6. Magnetron. 7. ...
...loop. Pull the plug for a minute or two to reset it. Check the power diodeThis electronic component is responsible for transmitting current in one direction. If the diode becomes defective it will ...
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions