Questions & Answers for: Ford Explorer do loop codes

...Bank 1 Sensor 1 and still get the same DTC code. The Freeze Frame Data reads: Fuel System 1 Closed Loop Calculated Load 43.5% Engine Coolant Temperature 199 Deg F STFT Bank 1 -4.6% Lift Bank 1 -3.1% ...

Ad

Question about 1998 Explorer

2 Answers

p0125 obd code how would i repair obd code p0125 P0125 Insufficient Coolant Temperature for Closed Loop Fuel Control This means that the engine coolant temperature (ECT) sensor indicates that the ...

Ad

...CODES Lieves DIAGNOSING it Fairly Simple. Morning Starts (COLD START) is a CLOSED LOOP Condition and by the time it warms up it closes LOOP and the ECM takes over the Timing, and compisates for the ...

...my problems, back on year later. Check for vacume leaks. You are getting excessive fuel.The closed loop temperature is not getting reached.There for it is running too cool.Your sensors are

Question about 1996 Explorer

1 Answer

...codes P0125, P0756, P0340....are these costly repairs? P0125 is Insufficient Coolant Temp For Closed Loop Fuel Control P0756 is Shift Solenoid B Performance or Stuck Off P0340 is Camshaft Position ...

...sensor do i need to replace The code says that engine temperature was not reached to allow closed loop operation. Basically the coolant temperature sensor did not inform the ECU that the engine had ...

...others have a learn procedure to determine closed throttle. PO171 Fuel Trim System Lean = In closed loop the PCM adjusts fuel delivery based on H2OS 1 readings and is indicated by long & short ...

...right side of the instrument panel) monitors the resistance of the driver side air bag circuit loop and the air bag module igniter at RCM, if the resistance is greater than 3.6 ohms, the RCM

Question about 1998 Explorer

1 Answer

...Conditions Cause Engine running at steady state highway conditions for 5 minutes in closed loop, then the PCM detected that the rear HO2S switch rate was too high so, with this info of the ...

Question about 1994 Explorer Limited

3 Answers

...only occurs after the car reaches operating temperature when the electronics changes from open loop to closed loop control. That means when it is cold it is running off of preset values. When it ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Explorer
1998 Ford Explorer

2,998 Questions

1996 Ford Explorer
1996 Ford Explorer

2,307 Questions

1999 Ford Explorer
1999 Ford Explorer

2,248 Questions

2002 Ford Explorer
2002 Ford Explorer

2,302 Questions

2004 Ford Explorer
2004 Ford Explorer

1,513 Questions

Manuals & User Guides

Loading...