Questions & Answers for: lock fuse blows Heating & Cooling

...lock relay located on a 1999 ford explorer? Electric door locks blows fuses. After replacing a fuse, the door locks will only work for a short time then blows fuse. I know the fuse/relay box is under ...

Ad

...a 15amp fuse but not the stop light fuse. Its possible there is a short some where that has connected these two circuits. You could disconnect the shift lock solenoid to see if the fuse still

Ad

Question about 2002 Tracker

1 Answer

...However, the fuse that blows is the one that controls the electronic door locks. The warning light may not have been reset, door lock actuator bad creating a short - blowing fuse, or bad

Question about 2002 Tracker

1 Answer

...lock when I can m38 fuse to see if this would do the trick, the fuse keeps blowing , not sure how to fix this problem. the parts are shorted, the FUSE stops the fire. and flames. we fix this buy ...

Question about 1996 Cherokee Country

1 Answer

fuse on jeep ,could it be one of the door locks You have a dead short and yes it could be in one of the door lock switches, figure out which one is blowing the fuses and take it out, might just have a

Blows fuse afer a journey when fuse to central locking blows and replaced if vechile is stationary ok but if driven for a short time it blows again try going to a higher fuse not to high tho like 5 or

...fuse. it only blows with remote key lock changed the relay. checked the horn. current goes into the steering shaft. but doesnt return to horn to make it blow. horn only works when i lock car with ...

...lock/unlock relay location There is a fuse #8 in the rear cargo fuse panel that controls the rear door locks and fuel door Lock. there are a whole bunch of relays in the REM that control different ...

...lock fuse blown, replaced it and it blew again immediately. You have a short somewhere in the system. Maybe one of the lock actuators or a switch. To test disconnect all locks and switch then replace ...

...lock blows a fuse where do I start?? Remove the fuses to the circuits that blow. Then one at a time, install a fuse, turn any component on and see if it blows the fuse. Have you had an accident ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...