Questions & Answers for: lock fuse blows

Ad

...lock relay located on a 1999 ford explorer? Electric door locks blows fuses. After replacing a fuse, the door locks will only work for a short time then blows fuse. I know the fuse/relay box is under ...

Ad

Question about 1999 Grand Am GT

1 Answer

when shift into drive auto door locks blows fuse I would guess that one of the locking mechanisms is stuck and will not lock. The actuator is still trying and blows the fuse. I hope this helps.

Ad

...a 15amp fuse but not the stop light fuse. Its possible there is a short some where that has connected these two circuits. You could disconnect the shift lock solenoid to see if the fuse still

Question about 2002 Tracker

1 Answer

...However, the fuse that blows is the one that controls the electronic door locks. The warning light may not have been reset, door lock actuator bad creating a short - blowing fuse, or bad

Question about 2002 Tracker

1 Answer

...lock when I can m38 fuse to see if this would do the trick, the fuse keeps blowing , not sure how to fix this problem. the parts are shorted, the FUSE stops the fire. and flames. we fix this buy ...

Question about 1996 Cherokee Country

1 Answer

fuse on jeep ,could it be one of the door locks You have a dead short and yes it could be in one of the door lock switches, figure out which one is blowing the fuses and take it out, might just have a

Blows fuse afer a journey when fuse to central locking blows and replaced if vechile is stationary ok but if driven for a short time it blows again try going to a higher fuse not to high tho like 5 or

...lock/unlock relay location There is a fuse #8 in the rear cargo fuse panel that controls the rear door locks and fuel door Lock. there are a whole bunch of relays in the REM that control different ...

...lock fuse blown, replaced it and it blew again immediately. You have a short somewhere in the system. Maybe one of the lock actuators or a switch. To test disconnect all locks and switch then replace ...

...lock blows a fuse where do I start?? Remove the fuses to the circuits that blow. Then one at a time, install a fuse, turn any component on and see if it blows the fuse. Have you had an accident ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85104 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

21762 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...