Questions & Answers for: Chevrolet lock cover

Question about Chevrolet

1 Answer

...lock and new cover gasket. Fill with 75-90wt gear oil. Now I know that sound pretty straight forward. But there are some things to remember. The E clip lock can be difficult to remove sometimes. The ...

Ad

Question about 2004 Silverado 1500 Crew Cab

1 Answer

lock actuator and its real easy their are a few cover plates on trim remove and take out the srews then take off the interior mirror cover / then take the door panel lift upwards and out the after you

Ad

Question about 2004 Silverado 1500 Crew Cab

0 Answer

...cover remove lock bolt than slide out pinion shaft have someone push in on axle and remove c-lock do 4 both axles w/c-locks out remove axles carefully pry off oil seals-will need bearing puller and ...

Question about 2004 Silverado 1500 Crew Cab

1 Answer

...cover will pull out.remove the steering wheel depress the lock plate (requires special tool) remove circlip and tool remove horn terminald (white connector with 2 copper terminals)pull straight ouit ...

Question about 2001 Suburban

1 Answer

steering wheel covers i cant gvet the covers off around the lock cylinder I hope this helps....these are the steps to removing and replacing the cylinder: Remove the knee bolster. Remove the steering ...

...cover to access the fuse block. Check the position 13 (Power Amp, Cigarette Lighter, Door lock Relay, Power Lumbar Seat) and A position (Power Door lock, Six-way Power Seat, Keyless Entry Module). ...

Question about 1996 C1500

1 Answer

...switch assembly out from the bulk head connector. Detach the key alarm connector from the lock assembly. Remove the ignition switch mounting screws and the ignition switch from the steering ...

Question about 1999 Silverado 1500

1 Answer

...lock screw ..install cover with bead of silicon or gasket and all bolts fill with fresh rear end fuild {on right side screw out plug half way up housing} until it starts to come out fill screw plug ...

Question about 1999 Silverado 1500

2 Answers

...cover ignition lock cylinder replacement on most vehicles. At this point... the only "tip" that I can think of to try would be to lightly tap on the head of the key while trying to rotate it at the ...

Question about 1999 Silverado 1500

1 Answer

...will pull out. The button is in the lock itself and it is what holds the lock in the column. Sometimes there is a hole in the cover and other times there is not and the cover will need to be

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...