...the mass air flow sensor and PCM and I steel have the problem the intake air temperature sensor is reading -15 F. Have you replaced your PCV hose? If it gets sucked in it will cause a lot of
...thinking if not pump it could be mass air flow sensor. any help would be great. Thanks Rick I had the same problem. found that one of the vacume house was burned out. Replaced it all okay
...mass air flow sensor. any help would be great. Thanks Rick jerking at idling slow accerating. cylinder #1 is missing. Did you change spark plugs and wires? The fuel pump wouldn't cause a miss, and if ...
...mass air flow sensor is probably bad. You should replace it. it is normally located between the air filter and the throttle body. It senses how much air is going into the throttle body so the car ...
...mass air flow sensor clean mass air flow sensor where is this sensor located on the mazda millenia 2002 2.5L? MASS AIR FLOW SENSOR IS ATTACH TO AIR DUCT TO AIR CLEANER HOUSING. Look in the oulet air ...
...and wires have been changed. Mass air flow sensor was changed. check the oxy sensor operation if the sensor has failed the car will run rich and start to chug. this can also be a intermittent ...
...from pcv valve and 2004 Mazda MPV vacuum line from pcv valve and intake is closed flat. New mass air flow and hoses and pcv valve. You have the wrong type hose on the pcv valvle. It isn't vacuum
...mass air flow sensor, its build inside maf sensor.you will have to replace mass air flow sensor to replace intake air temp sensor, make sure connection at maf sensor is good if so replace maf sensor, ...
...Location Chart-2000 MPV 1 PCM 2 Mass air flow (MAF)/intake air temperature (IAT) sensor 3 Throttle position (TP) sensor 4 Fuel tank pressure sensor 5 Engine coolant temperature (ECT) sensor ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions