Questions & Answers for: location ignition control module 1988

ignition control module location on ford ranger 2.3L engine 4 cylinder. It does not have an ignition control module. The PCM (powertrain control module) fires the coil pack based on signal it recieves

Ad

Question about 1988 Ranger

3 Answers

...sensor and Distrib.Ignition control module. what do you think. Should I change the fuses or plugs and wires first their going to need them anyways or I have no idea where theIgn. control module ...

Ad

...ignition module. They aren't too hard to replace, but you need a special tool. The module is located on the distributor stem at the back of the engine. Its held on by two small screws that need to be ...

...location ignition control module 95 ford ranger 2.3 dual spark plugs. please help been look for ot two days look behind the alternator by the ignition pack. it should be a plug on top WHERE IS THE ...

Question about 1993 Ranger SuperCab

1 Answer

...IGNITION CONTROL MODULE. For 1993 Ford Truck Ranger 4WD 3.0L MFI 6cyl the Control Module-Ignition is located under hood, center, rear engine area, mounted on distributor. Fig. 1: View of the remote ...

Question about 1988 Ranger

1 Answer

ignition control module, it is called the "TFI"? That is the most common source of a no start. There is also a problem with the ignition starter switches coming apart and causes a loss of power to the

...ignition module, i will encolse a picture and also tell you where to locate it. there are many auto part stores that can test your to make sure its bad. good day.there are a few engines that come in ...

...is the ignition module on the 88 ranger 2.3 liter The ignition module should be on the drive side finder you will have spark plug wire someing off of it. It is a black module with 4 bolts that are ...

location of ignition control module where is the ignition control module located Check for a Thick Film Integrated (TFI) Module attached to the outside of the distrfibutor with about an 8 wire plug on

ignition cotrol module location My 1996 ford ranger 4cly 2.3 starts and runs good for awhile.Then stalls and won't start for several hours. I have changed the fuel pump and filter. I'een told that the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...