Questions & Answers for: linkage shifter broke

...linkage broke on the shifter. Before it broke, the shifter was loose, now it hangs free and will not change gears. Is this a job I can do myself? And will I have to pull the steering wheel to do it? ...

...shifter linkage broke Plastic piece that connects shifter lever to shifter level broke.....how do I repair and what parts do I need......Part numbers would be helpful. there is a recall for that ...

...WITH JUST THE PAN DROPPED.ANY INFO WOULD BE GREATLY APPRECIATED disconnect the shifter cable linkage at the trans. then shift the trans through the gears. if it shifts easily ,replace the shifter ...

trans. that moves for gear selection and that ball brook off end of shifter. if its got a linkage set up most likely samething either shifting arms came off or shifter broke where linkage rods connect

linkage broke on transmission now car will not shift out of drive shifter linkage brokenow car will not go out of drive driveshaft broke

...shifter moves freely in the gear box like some linkage broke driving in 1st gear and then the shifter all of a sudden could move freely and i cant get it out of first gear like a pin or linkage brok. ...

...the shifter. Verify the linkage arm moves with the shifter. If not, then look closely at the linkage arm and bottom of the shifter shaft to see if either broke or if the clip is missing. Good

...of the car and see if the linkage between the shifter and tranny are intact? Have someone move the shifter whil your looking at the linkage, this will tell you whethr it is internal or

shifter cable broke go back to the linkage at the trans and find the bracket the cable attaches to and try to pull the cable through if you can it broke that's why I think the shifter lever is now all

I suppose you could make up your own pulley device to shift gears. Trace the shifter linkage/cable to the transmission should be a rotational type shift as on a vehicle (automatic). I hope this helps