Questions & Answers for: line 6 ii spider sound

Fender Hot Rod Deluxe. It has very few hours of service. However, often, when I turn it on and switch from standby to power - I get a blast of feedback. I can get it to stop, usually be switching back

fender hot rod deluxe static This often due to a cracked circuit board or bad solder joint. Sometimes input connectors are bad but those are easily discovered by wiggling the plug.

Fender Hot Rod Deluxe problem. Only one 6L6 glows, swapped tubes, left-hand one still no glow. Brittle, bad sound. Just a player, not an amp guy! Thanks. This sounds like a bad solder joint or cracked

...fender rot rod deluxe has almost no power, the volume its very very low, clean sounds distorted. Before lose the power, the clean already sound distorted at low volume, like at 4, its starts to sound ...

Fender Amplifiers are notorious for their reliability issues.However, I'm sure that amp will sound sweet once you get everything working again! The problem is likely your "tank". The tank contains the

...sound gets a bit distorted,the amp is the fender hot rod deluxe, ithort i may had blown the speaker or pre amp tubes.but the volume has never been past 6 and that was only for a short time,so i dont ...

Fender Hot Rod Deluxe On/Off switch wiring and Fuse Wiring I recently bought a used fender hot rod deluxe. I am doing one of the fromel mods to it and when i started i forgot to mark the black cable ...

...Fender Hot Rod Deluxe shows a 2-button footswitch as standard but I'm confused. This link shows it as connected to the amp via a mono cable ... FENDER Hot Rod Deluxe DeVille Footswitch which is ...

Fender Hot Rod Deluxe You have to ask the question for us to try to get an answer.

fender hot rod deluxe sn#b034418 how old The Fender Hot Rod Deluxe has been around since 1996