Questions & Answers for: lincoln continental lights stay

...lincoln continental cluster does not work. 1990 lincoln continental. open the door, with out key in switch, and the instrument panel lights up and stays on until you either put the key in and turn it ...

...Lincoln Continental stay on. THe cover of the fuse panel has all of the fuses numbered - not labeled - and says SEE OWNERS MANUAL, however I do not have the owner's manual. Any suggestions on this? ...

...lincoln continental interior lights stay on. The interior lights go on at stop sign/red lights...also when idle in park & when ignition is off, I understand this may have been a city cab previously, ...

Lincoln Continental Executive car fixed after sitting for 8 months. Now when i got it back the ABS light is on and the speedometer stays at 0. I know someone on here the ABS sensor is the problem. The

...lincoln continental w/check engine light staying on I have a 2001 lincoln continental and just replaced the thermostat-- the check engine light is still staying on solid, but it's not overheating am ...

...lincoln continental My interior lights always stay on inside faulty dooor switch ,,,, swop left to right it's bad keypad, the keypad light is on by itself then trigger the interim lights. it used to ...

lincoln continental will not start New fuel pump, and new crankshaft sensor. The volts read .24 at the crankshaft sensor Does the theft light stay on or flash on the dash when you crank it..could be a

...lincoln continental interior lighting stays on CHECK DOOR SWITCHES. OPEN DOORS ONE AT A TIME AND PRESS THE SWITCH IN ( AS IF THE DOOR WAS SHUT ) . WORK THE SWITCH IN AND OUT. THE SWITCH COULD NEED TO ...

...lincoln continental battery light stay on because there is no output or below voltage out put from the alternator. Check that the battery terminals and posts are shiny clean and tight, if there is a ...

lincoln continental Probably a bad door switch. It is possible the door switch is bad, or having issues. The WD 40 to all doors latching mechanism worked ! I used a screwdriver to rapidly simulate the