Question about 2000 FLHT Electra Glide Standard
...light didn't come on before the rebuild. the only way to check the oil pressure switch is to remove it and replace it, or test with a analog guage, if the pressure at idle is 5psi or higher at idle ...
Question about 2001 FLHT Electra Glide Standard
...switch is the problem. I would imagine that the changes have been made behind the headlight. Pull the head light out and look at the head light wiring harness. It should have three wires, yellow, ...
Question about 2001 FLHT Electra Glide Standard
...light switch in the right handlebar switch housing is broken. The rear brake light switch is a pressure switch located in a tee fitting in the metal brake line going to the rear brake from the rear ...
...light switch. To find it, find the metal brake line coming out of the rear master cylinder going to the rear brake. Follow this line and underneath the bike you'll find a tee fitting with a ...
...light switch is? Your bike is equipped with two brake light switch, either of which should cause the brake light to come on when activated. The front brake light switch is in the right handlebar ...
brake light switch location Hi Anonymous, the font brake light is in the right handlebar switch housing and the rear brake light switch is located in the rear brake line tee. Have nice day.
Question about 2001 FLHT Electra Glide Standard
...Light Key Switch not in IGNITION position. 2.Engine Stop switch in the OFF position. 3.Discharged battery, loose or corroded connections (solenoid chatters). 4. Bank Angle Sensor tripped and ...
Question about 2001 FLHT Electra Glide Standard
...Light Key Switch not in IGNITION position. 2.Engine Stop switch in the OFF position. 3.Discharged battery, loose or corroded connections (solenoid chatters). 4. Bank Angle Sensor tripped and ...
Question about 2001 FLHT Electra Glide Standard
...Light Key Switch not in IGNITION position. 2.Engine Stop switch in the OFF position. 3.Discharged battery, loose or corroded connections (solenoid chatters). 4. Bank Angle Sensor tripped and ...
Question about 2001 FLHT Electra Glide Standard
light wires from the switch, use one wrench to hold the fitting with and use another to loosen and renove the switch, replace the switch, install the two brake light wires, bleed the brakes and if you
Usually answered in minutes!
92 Questions
83 Questions
76 Questions
62 Questions
10 Questions
