Questions & Answers for: Mercury Villager light switch

light switch.. it is located under dash ..follow the brake pedal up you will see a switch ... unplug wires and use a paper clip or piece of wire to to jump... if brake light comes on replace switch...

...overdrive isn't engaging when the switch is hit and no light on dash when you press the o/d switch on the end of the shift lever, you are turning off o/d. WHen you do this, it turns the o/d light

light switch I replaced the lower break light switch on my 1998 Mercury Villager as the old switch would cause the break lights to stay on even after i stopped the vehicle running my the battery down.

light switch by the brake pedal and i notice another switch controlled by the foot pedal. What does this switch control? Thanks. I have a 1999 mercury Villager . I was adjusting the brake light switch

...light switch , now the breake light does not work at all. I did check fuse it is good. bulbs and good too . the switch I was replaced is also good. ( i do have another villager I did check on that) ...

light stay on even if the car is turned off. I assume that the switch located near the brake pedal has gone bad. Any other suggestions? check the brake switch. it controls a brake relay which may have

...light switch the lights go on, when I turn on the light switch the rear lights go off. I changed the fuse in fuse box and nothing has changed. sounds like a bad headlight switch, when lights are ...

...light switch located on or near the brake pedal mount. Either it is out of adjustment, or is broken. Try disconnecting the wiring harness connector from the switch and see if the brake lights go out. ...

...light switch electrical connector. Disconnect the emergency warning switch electrical connector. Disconnect the SECURITY indicator light electrical connector. Disconnect the speed control on/off ...

...light switch above the pedal, but can also be the relay. First find the switch above the pedal and take the connectors off. If the lights go out, replace the switch. If not, please get back to me for ...