Questions & Answers for: Mercury light switch

Ad

light switch I replaced the lower break light switch on my 1998 Mercury Villager as the old switch would cause the break lights to stay on even after i stopped the vehicle running my the battery down.

Ad

Question about 1987 Lynx

1 Answer

...light just when I installed more fog lights to one switch, I'm trying not to have 8 switches on my dash you need to use a heavy gauge wire and a higher amp switch be prepared for a switch to cost you ...

Ad

...switch until the light goes off. Replace culprit switch. retest for normal operation one of the door switches are stuck. most likely the drivers door, sometimes you can spray a LOT of penetrating oil ...

...light switch the lights go on, when I turn on the light switch the rear lights go off. I changed the fuse in fuse box and nothing has changed. sounds like a bad headlight switch, when lights are ...

Question about 1993 Grand Marquis

3 Answers

...light switch. If you are using the autolamp position on the light switch, this is a different circuit. The autolamp system needs the light sensor to work. If the light sensor is dangling under the ...

light switch working correctly. turn signals & tail lights work correctly. The third brake light is working correctly also... better get a second look at the brake light switch, there might be two

Question about 1998 Mystique

2 Answers

...go bad and makes contact inside switch and makes dome light stay on. try spraying them first. have a good day!! there may be one or more bad switches. check dome light and see if switch is stuck

light switch on a '94 Marquis with factory alarm and keyless entry? Here you go. I think this may be what you are looking for. I hope this helps and good luck. 1994 Mercury Grand Marquis Alarm, Remote

...light switch lights work My brake lights will not work intermittently. If I wedge a piece of paper in the hazard light switch then they will work...hopefully. Any help will be very much appreciated. ...

...work backup tail lighs parking lights don't work back up lights run from the transmission switch, no fuse. parking lights could be a fuse, light switch, or turn signal switch/multifunction

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Mercury Experts

gerry bissi

Level 3 Expert

4387 Answers

Marvin
Marvin

Level 3 Expert

85160 Answers

fordexpert

Level 3 Expert

5692 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...