Questions & Answers for: Cooper Wiring Devices light switch

...light switch to a combination switch/ outlet with the outlet being hot all the time and the switch going to the light? hey can you give me more detail? Is it a two gang box? Is the outlet and switch ...

light switch runs the hall light independently without trigger each other off? you cannot cobine two hot wires to two different lights to one switch you must run each hot wire to seperate switches but

...so you will need to either only put the sensor on one end and wire all the legs together on the other end (this would act as a regular light switch) or find somewhere that has the 3 way motion ...

...light switch You only have two wires, because it is wired for a switch leg. You only have the incoming hot and outgoing hot to the light. You need a neutral and grounding conductors also. If you're ...

...light switch at the top of the steps, you will have to seperate these two switches. Make the bathroom a switch by itself, and then connect the two way switches. If a circuit is not making a loop it ...

light switch to a gfi recp not having much luck with getting it to work properly i got 2 conductors from the panel and 2 conductors going to the gfi recp and on the switch i have silver terminal,brass

...light switch here in my office. Dang instruction sheet shows wiring for all kinds of cooper devices. EXCEPT pilot light switch. So I tested with multimeter and came up with following: Key to any ...

switch. If the light will not light (in either position of the other switch), then your red and shiny are your travelers, your test is done. If the light DOES light, then dull is one of your travelers

Switch doesn't work I switched out my standard switches for the charcoal grey aspire dimmer switches. The wiring has been double checked, and is correct. However, the lights will not turn on, let ...

...happened and now the light never goes on in the garage ( I have changed the bulb and made sure it was a good one) and the pilot light on the switch never goes off. Any suggestions? change the ...