Questions & Answers for: Hyundai Santa Fe light bulbs

Question about 2002 Santa Fe

2 Answers

changing fog light bulb I just replaced the fog light bulb on my 2008 Azera. I went under the car and removed two screws from the protective shield. I pulled down the shield and reached up and turned ...

Ad

Question about 2007 Santa Fe Limited

1 Answer

2007 Hyundai Santa Fe - Replacing fog light I need to replace a fog light bulb in my 2007 Hyundai Sante Fe but I can figure out how to get to it. I notice in the manual it says this bulb is best ...

Ad

Question about 2003 Santa Fe

1 Answer

...and in the well of the hatch you'll see two big screw that hold the black trim that holds all the lights on the rear right side and the same for the left. Once you take of the whole console (it's a ...

Light bulbs are usually accessed from the rear of the bulb housing. Locate the plug/socket with two wires going into it, rotate 90 degrees and pull socket and bulb out of the back of the fixture. Pull

Question about 2007 Santa Fe Limited

2 Answers

light bulbs. What is needed to install them? Fittings differ from original. Its a 2009 model. If your looking at a larger "fitting" it may be pulled off the bulb and installed on the new one. Then fit

Question about 2007 Santa Fe Limited

2 Answers

filament bulbs. So the tail light bulb might still work when the brake light filament is burned out. Could also be a switch located by the brake pedal but is most likely a bulb. Replace the bulb first

Question about 2007 Santa Fe Limited

1 Answer

...You could ask the dealer parts counter for the pilot light bulb, by looking at the parts catalog, you could also see the how many bulbs in there. Hope that solve your problem! Thanks for using

Question about 2002 Santa Fe

1 Answer

...light assemblies in which the socket and bulb are removed from the back of the assembly.The bulbs are held in their sockets in a number of ways.Some bulbs are simply pushed into and pulled out of ...

...light bulbs out and check to see it there is power coming back at all, with a volt meter, if there is may have to clean off the contact points where the bulb fits in, if not may have to trace the ...

Question about 2002 Santa Fe

1 Answer

how do you access the outside tail light to change the bulb on a 2008 Hyundai Sante Fe? You can access the bulb by going to the rear of the car and removing the internal side panels at the opposite ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...