handle and lift up and out. (Figure 3) Figure 3: Remove drum cartridge ******Very Important*************** To reset the NVRAM, perform the following steps: Press the Menu button. Press the (down arrow
...to move across the printhead in only one direction. When you pull it out to its full extent, it is lifted up so that when you push it back, it is actually above the glass, not on it. When it reaches ...
...to move across the printhead in only one direction. When you pull it out to its full extent, it is lifted up so that when you push it back, it is actually above the glass, not on it. When it reaches ...
...cartridge on dell 3010cn printer? pull open the front cover lift up the top cover lift up the blue handle on the right pull the blue handle in the middle up that is the drum unit steven ...
...(that is left while you are looking at front of the computer) and slide panel out towards back, lifting it slightly. 4. locate processor and next to it, towards front of the computer are located
...pretty sure that it is responsible for the fact that the paper feed tray doesn't work anymore. I hate this printer. Really. Lift up on the lid, and push the handle inwards, then push the lid
...lift it up and away from the printer. 3. Unpack a new toner cartridge. Hold the cartridge carefully and thoroughly shake it from side-to-side 5 or 6 times to distribute the toner. 4. Pull the tape to ...
...lift up the keyboard, starting from the front where the screws were. Then grabbing the small wire handle, unplug it from the motherboard. Once removed, place the new keyboard in by plugging the cable ...
...Push the rear cover release handle and open the rear cover. 2 Lift up the fuser release levers (2 blue Handles behind the rear Door) 3 Lift the Fuser up and out. to re-install, just do the ...
Usually answered in minutes!
995 Questions
574 Questions
608 Questions
501 Questions
509 Questions