Questions & Answers for: Chevrolet how do you lift the handle

...Lift the entire panel to unhook the top edge which hooks over the sheetmetal at the bottom of the window opening. The trim around the doorhandle is held in place by three three j-hooks which must be ...

...handle to lift the door. The right side releases as normal, left side will not. I do not see any way to remove inside panelling short of ripping it off with the lift door still closed. Is there a ...

...lift up to remove? On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining ...

...lift the door handle up and I guess I yanked it too hard and it popped off the door help me please look to see if any damage to handle no damage replace[damaged get a new one salvage/dealer]take off ...

the front door handls are not openinig the front doors,and if I fiddling with handle lifting up and pushing in at the same time it will release and open.do I need to replace the handls or is there ...

lift the handle, they should retract inside the tailgate. When you let go of the handle they should pop back out. Mine would stick in when I lifted the handle so they didn't pop back out when I let go

...twist the clip off the arm of the handle rod and lift out then remove the two nuts and slide out the handle in stall in reverse hope this helps you out please leave a review thanks sincerely ...

...and the plastic clip that holds the rod into the handle neeeds to be rooled back so the rod can be lifted out then with the nuts removed the handle can be wiggled

... then insert a small screw driver to pop the small taps loose around the outer edges of the door handle trim ring, then lift the door panel straight up. drill the rivet out and slide the handle ...

...handle on the lift gate and remove it. Mine had two cover pieces over two 10mm bolts. Under the handle and handle plate you can access the push rod for the left side latch. Mine snapped back into ...