lift the printing mechanism and slide the cartridge out .this will fix the problem of the stuck cartridge ,but I had the same problem with the next cartridge so will probably end up throwing the thing
...A BUTTER KNIFE AND PRY UNDER SLIVER DOT)NOT HARD BUT WITH ALITTLE FORCE SHOULD POP OUT. REMEMBER TO LIFT GREEN TAB WHILE PRYING. IF STILL STUCK MAY BE STUCK IN PRINT MODE THATS BEYOND ME. GOOD
Question about EASYSHARE Printer Dock Thermal Photo
...Lift up on the Green release button on the inside and your cartridge should come free on its own. Be careful not to try and pry it out for this can void your warranty! ...
Question about Carousel 4400 Slide Projector
lift arm on the screen. The tray does not properly mount on the projector and the For and Rev controls do not work. You are describing, among other things, a timing problem with the projector. That is
how do you un jam paper stuck in the printer? LIFT UP PRINTER AND PULL PAPER OUT FRON UNDERNEATH.JOB DONE.
...gate. This is the Lift Lever, which raises & lowers slides into the Gate. With the tray off, cycle the projector a few times. Did the Lift Lever go up & down? If it stayed at the top, chances ...
Question about Carousel 4600 Slide Projector
...gate index, any ideas on how to fix? Two steps. 1) Look down into the center of the carousel. There should be a round, flat silver knob with an elongated notch in it. Take a coin (US 5-cent piece or ...
Question about Ektagraphic III ATS Slide Projector
stuck First of all, the shutter will only open IF there is a slide in the gate. Assuming there is a slide in the gate, there are 2 things that could be preventing the shutter from opening:
Question about A Ektagraphic 35mm 140 Slides Rotary Carousel, 80 Slides Rotary Carousel Slide Projector
lift the tray off. Flip the tray upside down. Remove the jammed slide from the optical gate of the projector (inspect it for damage - "dog-eared" slide corners cause this kind of jam) and re-insert it
lift gate tray Does there need to be slides in carousel in order for the carousel to move forward or reverse? No. The slide tray should rotate when the forward or reverse buttons are pushed. Slides ...
Usually answered in minutes!
1,024 Questions
996 Questions
1,049 Questions
812 Questions
732 Questions