Questions & Answers for: lid won't open

Question about S4210 Antares Bagged Canister Vacuum

1 Answer

lid won't close. It's stuck at 90 degree angle. Is a button to release it? Hi bndennis, Please check the spring on your lid, it may be keeping the door open. Miele vacuum cleaners mainly use a

Ad

Question about TAWS850PQ

1 Answer

...won't wash or spin with the lid open so I suspect you have a broken lid switch. IF that turns out not to be the case then I would next check the motor start capacitor. When these fail the motor ...

Ad

dishwasher soap cup lid won't open dishwasher soap cup lid won't open? If you can't find anything to pry it open with,just call the manufacturer or store.

...won't run with the lid open,a kid could open the lid when it's spinning and it won't shut down and if the kid sticks his or her hand or arm inside it could get ugly so it's a safety ...

Question about 2007 Camry

1 Answer

...won't disengage trunk lock? There isn't anything stuffed in the trunk, so I know it's nothing jammed in the connections. Someone told me I would have to replace the actuator? About a $410 ...

...agitaion is fine. pump is fine. Water fill is fine. Agitation is fine, and stops when lid is opened. Pumps water out, but won't spin. Pump stops when lid is opened. Check/ replace motor ...

Question about 2007 Corvette Convertible

1 Answer

...lid won't open, its stuck shut & can't pry it up without risking some damage. The manual key turns in the key slot, but same thing, the lid won't release. I may have left a microfiber ...

2007 sky saturn trunk latch on driver side won't open trunk latch on driver side won't open A Saturn Sky is a 2 seater and has no rear fold down seats and no key to open the trunk lid.

...lid latch, can't find, won't open? I'm trying to open the storage lid/compartment to slide the manual soft top into it....I can't find the latch to manually open the storage ...

Question about Bravos MTW6600T Top Load Washer

1 Answer

lid won't lock the lid switch assembly might be defective. This is a very common problem. The lid switch assembly can fail either mechanically or electrically. Test any electrical switches with an

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Vacuums Experts

AskDyson
AskDyson

Level 3 Expert

2572 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

Anonymous

Level 3 Expert

43501 Answers

Are you a Vacuums Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...