Questions & Answers for: lid switch

...lid switch failure. Heres what the service manual for your washer says about the failure. Flashes if the lid is NOT opened after the cycle was completed. The electronic control board must detect that ...

Ad

Question about 24032\24036 Top Load Washer

1 Answer

...lid switch malfunction. If your model number is correct, the lid switch for your washer is located under the right hand side of the washer casing along the wash tub rim. The switch is activated by a ...

Ad

...lid switch. The lid switch will be located on the machine top where the lid closes. It may be a plunger on the lid that activates the switch or a white plastic flat piece where the lids sets. Either ...

Question about 23822 Top Load Washer

2 Answers

...Lid switch problem My Kenmore elite 100.24942301 has a problem with the lid switch. We close the lid to start the washing process, but after filling with water the machine does not start. It thinks ...

Question about 23822 Top Load Washer

1 Answer

lid switch problem My kenmore elite washer model 100.24942301 is having an issue with the lid switch. We close the lid and the machine doesn't start. IF we lift the lid and drop it, it starts washing.

Question about 23822 Top Load Washer

3 Answers

lid switch The most common cause of the symptoms you describe is a lid switch malfunction. The lid switch is usually mounted under the washer top casing, on the right hand side on most top load models

Question about Calypso GVW9959K Top Load Washer

1 Answer

...lid switch is not functioning properly. Raise the top part of the washer to gain access to the lid switch. Disconnect the machine from the power source. Gently pry the emblem from the front of the ...

Question about Calypso GVW9959K Top Load Washer

1 Answer

...lid switch too, just to be sure it is making contact.From what you are describing it sounds like the problem with your washer could either be the lid switch or no cold water. However there are a ...

...lid safety switch is bad. Replace the switch. If this is a unit with a hidden lid switch, left rear, you may only need tighten your lid hinge screws. Replace the lid switch assembly. By hitting the ...

...lid ajar switch • Rear compartment lid release actuator • Rear compartment lid release switch • Remote control door lock receiver (RCDLR) • Trunk fuses • Trunk release relay Rear Compartment Lid ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...