...Lid Lock Issue. For the FAV6800AW that is you machine type correct? The "LO" console error is "Lid has failed to unlock". I haven't experienced the "LO" error code to the display but this is the ...
...lid lock, Left Lid Lock. You don?t need to replace the right just unplug. Here is what is happen. The left lid lock and right lid lock ?Lid is Locked? signaling are in parallel going back to the ...
Question about Neptune FAV6800AW Top Load Washer
...lid lock clicks several times when you try to start the wash cycle. The locked light never comes on and it just sits without starting. I disassembled the left locking switch and cleaned the contacts ...
...Lid Lock Open Circuit Check Harness to Lid Lock and connections at the Motor Control Module and lid lock ends. Primary Fault: Connector to the harness. Either end could be at fault. Action: Replace ...
...Lid Lock Open Circuit Check Harness to Lid Lock and connections at the Motor Control Module and lid lock ends. Primary Fault: Connector to the harness, either end could be at fault. Action: Replace ...
...lid wont lock Is the lid lock tang on lid broken. 2.9 Lid Lock The Phase 7 Washer uses the same lid lock that is used on the Phase 6 series 11 & 12 machines. The difference being is that the lid ...
Question about NTW4700YQ Top Load Washer NTW4700YQ
...lid lock wont quit blinking washer was not in use and lid was up. lid lock light started blinking and now washer will only fill and drain-will not wash or spin Your washer lid lock button is locked ...
...lid lock keep flashing? changed lid lock but having the same problem. There is a right lid lock and a left lid lock which did you change? The left lid lock is a lock and the reed switch which tells ...
Question about Neptune FAV6800AW Top Load Washer
...lock the lid and stay standby with out working ? power off by unplug and wait few minutes and again tried but the result is same The unit will not operate in this condition until the lid lock signals ...
Question about Aquasmart wl80t65c
...LID LOCK & IT LOOKED A SALTY CORROSIVE TEXTURE ON EACH END OF CONNECTION. ALSO THE TOP LID GROOVE THAT SLOTS INTO THE LID LOCK HAS BEEN GROUND DOWN & IS NOT CONNECTING & PUSHING DOWN TO ENGAGE LID ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions