Questions & Answers for: lg dishwasher door spring replacement

...LG dishwasher it is as likely to be the cable/cord attached to the spring and door. This a very odd setup in that this cable is made of nylon cord, and not any thicker than a round shoelace! It ...

...LG LD-14AW2 dishwasher. It fills with water to the correct level but still has the IE message and wont start washing. I have the same problem. Could you please suggest me how you have fixed.Thanks in ...

LG Model LD-14AW2 - loud bang and door dropped open as if a door hinge or spring snapped. Are both sides of door normally supported. Are parts available to repair. Where do I get a manual. Colin Hello

leaks from door gasket.Should I change the gasket or the whole door? Thanks Replace the door seals/gasket. You also have adjustment on the door hinge springs. You need to remove side panels to get to ...

door falls down with no resistance i think the ropes and or springs broke Hi there Mathew, yep your diagnosis sound correct to me the LG dish washers have a string with a plastic lug that conects them

...door springs on lg model LDF6810ST The door just falls to the floor Found advice from another post for same prob..not tried yet says its not springs but spring cable, part #4933DD 3001B and 2 needed. ...

How do I replace dishwasher door hinge spring? LG model LDS5811ST http://www.repairclinic.com/PartDetail/b200p9/LG-Dishwasher-Hinge-Spring/4970ED4004D/1337779?modelNumber=LDS5811ST#repairHelpVideoTabs

door spring/assembly broken. How do I repair same? If it's like my whirlpool, pull it out. Spring should be obvious. I doubt the hinge portion is broken. Spring may be. While it's out and springs tend

...door. Using a headlamp, remove the kick panel and locate where the springs are attached to the lower frame. Now, using the coat hanger, hook the end of the spring that is attached to the cord. Pull ...

...door on my dishwasher opens too far and is not horizontal to the floor when open. The door springs and cables are in good condition. Is there an adjustment mechanism somewhere? Besides spring ...