Question about 2005 MR2 Spyder
...is laid out, bank 1 is always on the same side as cylinder 1. I cannot say whether the right hand or the left hand one will be bank 1 as I do not know where your cylinder 1 is. The garage should ...
...bank 2 is LEFT side (drivers) on a rear wheel drive vehicle ,on front wheel drive vehicles it would be the front side when looking down from the front of the vehicle ,Sensor 2 is after the cat ...
...bank - top Left to top right bolts 1,2,3,4 bottom row of bolts, on top bank - bottom left to bottom right bolts 3,4,5,6. Top row of bolts on Bottom bank bolts 1,2,3,4 bottom row of bolts on bottom ...
bank - top Left to top right bolts 1,2,3,4----------------- bottom row of bolts, on top bank - bottom left to bottom right bolts 3,4,5,6.------------ Top row of bolts on Bottom bank bolts 1,2,3,4-----
Bank 1=Left bank...Bank 2=Right bank...Looking from the transmission side..towards the drive belt side...Left bank=left...right bank=right...Sensor #2 is located behind the cat... Guru................
Question about 1992 Pickup
...left side is BANK 1 SENSOR 1 (upstream LEFT SIDE)- I JUST REPLACED - DENSO 234-9007 Fuel To Air Ratio Sensor , so now I have to replace the other side P1150 - DENSO 234-9009 Fuel To Air Ratio Sensor ...
...Bank 2 Notes The "A" camshaft shall be either the "intake," "left," or "front" camshaft. Left/Right and Front/Rear are determined as if viewed from the driver's seating position. Bank 1 contains ...
Question about 1992 Tercel
...bank will be in front of the driver ( LH drive cars) or in front of the passenger in RH drive cars Drivers side all cars left side Passengers side is right. Downstream usually is after the cat ...
...Bank 1 was on the left [under passenger],replaced sensor [upstream ] with a Denso brand, still has CEL showing ? On a front to back engine b1 is the drivers bank. On a transverse engine b1 is the ...
Question about 2011 Tacoma
...left side and Bank Two is the right side. There is a bulge in the exhaust nearest the engine which is the Catalytic Converter. Sensor One is before it and Sensor Two is after it. This is for both ...
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,565 Questions
1,303 Questions
1,231 Questions