Questions & Answers for: Brother HL led light

...LED's will light up and then 3. Once the 3 LED's are lit, release the GO button Press the GO button 2 times. This will cause the LED's to light solid With the LED's lit solid, press the GO button 5 ...

...led to... Open the front door, Push and hold the "GO" key for about 4 second, all leds are suppose to light...When alls leds light release "GO" key.... Now take the unit out of the printer ... By ...

...light goes on, not blinking, and no copies come out of the printer. tray this The procedure for the factory inspection mode is as follows. (1) Turn off the printer power switch, open the front cover, ...

...Yellow Status LED lights. When the status LED lights, release the Go button. When all the LED's light, the printer will start warming up. The print server has now been reset to its factory

good I would just reset the drum light by this procedure. Open front cover. Hold down button located under LED's until all LED's are lit. Release button and make sure drum LED is off, then close cover

...a very reasonable printer. --JMM Drum light reset: Open front cover. Hold down button located under LED's until all LED's are lit. Release button and make sure drum LED is off, then close

light on and off. what do I do? The Drum LED alternates on and off, turning on for 2 seconds and off for 3 seconds,and the Ready LED is on. the LED lights indicate the drum unit is near the end of its

...LED's will light up and then the STATUS LED will turn off. Release the GO button and the LED's will turn off. Press the GO button six times. Make sure that all the LED's light up to indicate the ...

i have a brother 5250 dn all the lights comes on when i tuning it on i have evn replaced the fuzer but still 1) If service call occour, all four leds blink on and off (Are you in this condition?) 2) ...

...back. Hi, if you status led become red and only that light is on must be 1 of the following problems: 1.- Front Cover is opened 2.- Memory Full 3.- Option Tray is installed too much 4.- Print ...