Questions & Answers for: latch assembly

...latch assembly. Drill out rivet at bellcrank and link (264B14). Remove three screws attaching latch assembly to door. Drill out rivet that attaches actuator motor to door. Remove latch assembly with ...

...latch assembly, via wiring harness, to assume the lock position. This is achieved by the control sending a electrical current through the wires, thus, causing the door latch mechanics to lock the ...

...latch assembly are broken. If one is broken, replace the door latch. If the door latch is ok, you might have to replace the door switch and the door latch. To replace the door switch you have to ...

...latch assembly (part number 8181700) to solve the problem. Disconnect power to the washer and open the door. Remove the door gasket retaining hoop by stretching apart the retaining spring at the ...

...latch assembly out and set aside.(4)Insert the new latch assembly into the hole left by the old latch bolt.Trim the recessed opening with a sharp chisel if the new lock latch plate is larger than the ...

...the handle is, work the throught the edge of the tailgate and fasten to the latch assembly, then install the latch assembly. Once both latch assemblies are connected, reintall the handle

...latch assembly (part number 8182634) to solve the problem. Disconnect power to the washer and open the door. Remove the door gasket retaining hoop by stretching apart the retaining spring at the ...

...latch assembly. l_1m a gj 9. Disengage the linkage rod from the latch assembly. 10. Remove the latch assembly from the endgate. Installation Procedure L Image 1. Engage the linkage rod to the latch ...

...Latch Assembly If the door won't latch, the latch assembly might be defective. Inspect the latch assembly to see if it is cracked or worn out. The latch assembly is normally replaced all as one part. ...

...latch assembly for lubrication. The grease may be too heavy when cold and cause the latch assembly to stick. You can try additional lubrication with WD 40 spraying in the latch assembly. This will ...