Lamp failure in WD-52525 Bought tv with dim lamp, went out after 20 hours. Replaced lamp and worked for 250 hours or so, but took 15-20 seconds to warm up. Lamp light comes on but lamp still looks new
Question about LP120 / 1000 Lumens / XGA / DLP Projector Refurbished Multimedia Projector
secured properly. I have the same issue. Swapped bulbs with a working LP120 and still get the Lamp Did Not Strike error. Lamp housing is secure and the fan is moving air. Its probably the lamp ballast
it be the Ballast??Thank for help. You should listen for a strike noise at the lamp or ballast area, 1 strike for each cycle. A weak lamp will take more strikes to start, until one day it never starts
...lamp didn't strike Also having this problem."Warming up" then "lamp didn't strike" then "retrying" stuck in a loop. It's at a school where I work and nobody has reported any messages regarding the ...
Question about LP120 / 1000 Lumens / XGA / DLP Projector Refurbished Multimedia Projector
Lamp will not strike error message I have confirmed the bulb is good, however unit will start and try to light the lamp. It goes through count down, gets to 4 and reads "retrying". It does this ...
...Strike Lamp will not strike in LP600. Receive message "Powering up...Wait..." then "Retrying". Eventually, a message is displayed "Lamp Did Not Strike". The cycle just repeats over and over again... ...
Question about TLP 680 Multimedia Projector
...power supply. the lamp gets about 250vdc until it reaches a certain point, then it drops to about 20vdc, but the high strike runs through a different part of the ballast than the maintenance
Lamp won't strike Replaced Proxima C160 lamp but get "lamp won't strike" message the ballast might be bad as well.
Question about Cinego D-1000 Multimedia Projector
...lamp won't strike. I never got a lamp life message. What could it be? Do you hear it trying to strike the lamp, like a spark type noise. If not then perhaps the ballast circuit is faulty, assuming ...
Question about LP640 Multimedia Projector
projector has not been pushed in as I have seen this happen on a couple of LP540 and LP640 projectors. If the connector is pushed in the connector on the lamp will not make contact and strike the lamp
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions