...lamp blub assuming I put it in correctly(as an exhaust verses air blowing onto the bulb) there are 3 leds on the front that blink the error code. which leds blink gives you the error. if its just the ...
3 flashing lights replaced lamp and when replaced,put on cover and 3lights start blinking...is there a reset button? the 3 blinking LEDs mean the lamp may be defective. Be sure the lamp is making ...
Question about HLN467W 46" Rear Projection HDTV
...lamps on front (timer, lamp & temp) are flashing. Timer & lamp led's flashing green, temp led is flashing red. Have unplugged several times, but no change. I would suggest replacing the ...
Question about HLR5067WX 50" Rear Projection HDTV
...lamp led blinks on and off for about a minute then temp and lamp led starts to blink. replaced lamp already CK your Lamp Fan if it is OK Ballast Board Call Encompas Parts Distrubtion or Visit their ...
Question about HLR5067WX 50" Rear Projection HDTV
...lamp led blinks on and Samsunh hlr5067wx no pic lamp led blinks on and off for about a minute then temp and lamp led starts to blink. Replaced lamp already check your fans. there's 3 of them. make ...
...be replaced it with a new lamp.No,LED light LAMP indicator flashing,than ur tv is a LCD or a Plama tv.Than ur power supply board is dead.Must replaced the power supply board to solved this
Question about SP 56 K 3 HV 56" Projection Television
...a new lamp,if "LAMP" LED light lite or blinking?The projection lamp in the tv now,been in use for at leat 2 years and tv on about 4 to 5 hours a day?The Lamp life span is over,require a new
...lamp or LED lamp first,see what happen?Than go from there?Tvs with "LAMP" LED indication light flashes,tv 1 1/2 or 2 years old use like 4 or 5 hours a day.The projection or LED lamp or bulb,inside ...
...lamp led flashes 2nd stand by temp led comes on 3rd lamp flashes 4th all three led's flash (timer,lamp,and stand by temp) I tried an original manufactured replacement lamp no help. I also held the ...
Question about HL-S4266W 42" HDTV
...part i need to replace: The LED driver or the LED strips? Measure the voltage that goes into the lamps, should be 100 volts give or take, if you have it then the lamps are bad, also measure with ...
Usually answered in minutes!
1,031 Questions
445 Questions
373 Questions
357 Questions
327 Questions