Questions & Answers for: Samsung HL lamp cover

...cover for lamp. 1 thermo 150.00 2 ballast 250;00 3 light engine 600.00 Get a tv service center to come over and check. it would be worth the service call ask him what he charges for road call , at ...

...lamp cover only one screw remove it and you will be able to see the back of the lamp 2 screws take lamp out and inspect it , if bad replace it. some sets will have lamp part number on the side also. ...

Lamp Cover Error! I have a HL-P5063W also. It is from August 2004 and few months ago the image started dimming. So i got a replacement lamp and put it in. But then the lamp fan became very nosiy every

...lamp cover switch. Earlier versions used a black plastic switch holder that may break due to improper assembly. The part number for the holder is BP61-01240A. Newer versions use a metal tab attached ...

...lamp cover at the back of the unit. Remove the lamp cover. Remove the screw securing the lamp. Separate the bulb from the engine by holding the handle and pulling it out. Follow the steps above in ...

...lamp cover; it takes a bit of force. Unscrew two more screws (one on the right and the left). They will remain on the body of the lamp. Separate the lamp from the engine by holding the handle and ...

lamp cover has been fixed back in place correctly, lamp cover is first thing that you removed from tv to replace lamp, it should be fixed properly after lamp replacement. Are you sure replacement lamp

...lamp cover on the back of the TV is properly positioned in the groove and secured by the screw. Take it off and check that the screws that hold the lamp itself are secure. There is an safety feature ...

...lamp cover and then remove the lamp cover. Remove the lamp cover duct by holding the locker and pulling it towards you. Next remove the screw holding the lamp in the housing. Separate the lamp from ...

...cover. [3]. Loosen the lamp by removing the security screw from the handle of the lamp. Though the lamp bulb is visible in the middle of the access panel, the handle is to the left of the panel [4]. ...